If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hardness
On Sep 6, 8:23 am, wrote:
Dirk On Sep 6, 5:50 am, Dirk Bruere at NeoPax wrote: Any easy way of measuring the hardness of a blade? There is no easy way to do so, but if you can get a set of reference steel samples tempered back incrementally, then you can do a pretty fair approximation with a file. You won't be able to go above Rc59 or so as the file will not touch it. I haven't tried it, but you may be able to do it with a diamond file. Regards Craig Say Hey: Hmmmmm! Wonder why Kombat Kramer hasn't stuck in snout in on this? 5555 Yee-Haw !! |
#2
|
|||
|
|||
Hardness
pinkieki wrote:
Dick Bruere wrote: Hmmmmm! Wonder why Kombat Kramer hasn't stuck in snout in on this? 'Cause he be busy, he's got his snout buried up to his ear lobes in yoose wimmin's pinkie slits. |
#3
|
|||
|
|||
Hardness
On Sep 6, 8:41 am, Sheldon wrote:
pinkieki wrote: Dick Bruere wrote: Hmmmmm! Wonder why Kombat Kramer hasn't stuck in snout in on this? 'Cause he be busy, he's got his snout buried up to his ear lobes in yoose wimmin's pinkie slits. Say Hey Tricky Dicky: Hmmmmm! I sees what youse means! One of or several of his sock puppets should be popping up soon. 5555 Yee-Haw |
Thread Tools | |
Display Modes | |
|
|