If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
tube noise
isw wrote:
In article , BEAR wrote: --snippage-- For audio applications though, achieving extrememly low noise levels isn't really a tremendously important issue, the exception being when amplifying really low level signals, like condensor mics and phonograph cartridges... assuming relatively good low noise circuits using tubes are what we're talking about - there are some very noisy tube units out there, and that's not a good thing. Usually the inherent noise in a noisy line stage can be reduced through better design/circuit changes, or changing out the tube type or selecting for a low noise example of that given type. I would argue that even a phono stage isn't all that critical. It's easy to design a preamp that's better than 10 dB quieter than the noise level of a stylus in a groove; shoot, that doesn't even take "low noise" technique. I don't think it matters if the preamp noise is audible when the stylus is *not* in the groove, BTW; not too many folks spend much time listening to that. I don't think you'd want to listen to a phono stage that was only 10dB quieter than typical stylus noise. Hum is part of that equation, and getting the hum out is important too. Solid state is easier than tubes for noise, but still an issue. More important would be low distortion, and that can be traded off against lowest possible noise by using, say, a differential input stage. Actually, "low distortion" is relative. Differential circuits tend to end up sounding rather more "hard" and "sterile" than non-differential circuits due to the spectra of distortion products being mostly odd order, and cancelling strongly the second harmonic. It has been shown in peer reviewed Journal publications that merely low THD does not translate directly to audibility of distortion. Consider that your signal is *modulated* by all low level artifacts, noise, hum, distortions etc... so the actual level of the nominal signal you are listening to being *above* the nominal noise/hum/distortion floor does not mean that it is unaffected by same. But as long as one is happy with what one is hearing, then all is well... As Count Basie said (iirc) "If it sounds good, it is good..." or was that Duke Ellington?? _-_-bear Isaac -- |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BEST TUBE ROUTE FROM HEATHROW TO PADDINGTON | Randall Rosenbaum | Europe | 11 | April 18th, 2005 05:32 PM |
Princess Grands aft suite how's the noise level? | Becca | Cruises | 1 | March 18th, 2005 06:55 AM |
Cabin noise on Crystal Harmony?? | Fred | Cruises | 6 | August 1st, 2004 09:15 PM |
London Tube - More Questions | Alan Harrison | Europe | 2 | January 28th, 2004 09:36 PM |
London Tube --Holborn staion | Freda | Europe | 11 | December 29th, 2003 04:36 AM |